Erosion Control

Grass Reinforced Spillway, Erosamat, Black Moss Reservoir, Barley, near Nelson, Lancashire UK

Project Information

Project:Ground works for reservoir spillway and to protect dwellings from potential flood waters
United Utilities
Contractor:Askam Construction
Consultant:GVA Livigunn
Product:Erosamat Type 3/20 G50
Benefits:- Slope erosion control suitable for high water flows
- Open 3-D matrix binds soil and promotes growth
- Allows an engineered green slope
- Speed of installation

Project Description

The upper and lower Black Moss reservoirs near Barley provide drinking water for Nelson, Lancashire, and were constructed in the late 19th century. A flood risk assessment identified a spillway upgrade was needed to protect dwellings further down the valley in the event of overtopping.

Concrete was deemed expensive and unsightly, so a grassed spillway was the preferred option to increase the water capacity in the event of an overtopping. This would allow water to safely pass by the dam and be directed away from the local properties into an existing waterway, ultimately draining away safely.

The Challenge

The proposed site for the spillway included a section of slope significantly steeper than the surrounding land. Hydraulic modelling showed flood water passing over this area could reach velocities in the region of 6m/sec. Studies such as CIRIA Report 116 have shown that well established grass can withstand flows only up to 4.5m/s for no more than an hour. In addition, with steeper slopes, there is a risk of landslip where subsurface flows can cause blow out further down the slope. A proven reinforced green solution which could prevent surface erosion and stabilise the subsurface preventing landslip was required.

The Solution

ABG’s Erosamat Type 3 Turf Reinforcement Mat (TRM) was specified by the Project Engineer to create a fully vegetated surface which could cope with far higher flows than unreinforced turf.

Erosamat 3/20Z G50 erosion control matting

ABG Erosamat 3/20Z 500M Turf Reinforcement Mat

Erosamat Type 3 erosion control matting is a three-dimensional matrix of thermally bonded polypropylene fibres which create a tough and flexible erosion control mat. Here Erosamat 3/20Z G50 was used which includes geogrid reinforcement within the structure and provides much higher tensile strength while still allowing a large open surface area to promote grass growth.

The integral geogrid was secured to the surface using ground anchors driven through the subsurface and held and tensioned against washers placed at the surface. This bound the top layer of soil to control the risk of uplift in a flood event. Additional “U” pins were placed between the anchors to ensure good surface contact. Topsoil and seed was brushed into the Erosamat Type 3 geosynthetic matrix to promote the quick establishment of vegetation across the area.

ABG Erosamat Type 3 with imported top soil laid on for erosion control on slopes and embankments

The ABG Service

ABG provided full technical design support for both the use of Erosamat turf reinforcement mat (TRM) and the fixing anchor regime to ensure the success of this project.

Contact ABG today to discuss your project or specific erosion control requirements and discover how ABG past experience innovative products can help on your project.

Erosamat Type 3 erosion control rolls positioned prior to unrollingErosamat Type 3 rolls positioned prior to unrolling
Erosion control Erosamat Type 3 geosynthetic unrolled down the embankmentErosamat Type 3 unrolled and place down embankment
Ground anchors driven through soil. Washer placed over cable and tensioned against the geogrid.Ground anchors driven through soil. Washer placed over cable and tensioned against the geogrid.


Login for Access